Edward Fire Alarm System

Approx. 2,500 / Piece Get Latest Price

Product Brochure
Edwards provides fire alarm systems, fire detection systems, life safety systems, fire alarm panels, fire alarms, notification systems

Get best price for G1AVRF Sounder Horn Cum Strobe Est Edward

Approx. 1,500 / Piece Get Latest Price

Product Brochure
SOUNDER G1ARF MAKE EDWARD Overview Genesis LED G1 Series horns and LED strobes feature a sleek low profile design and energy-efficient technology that makes them less expensive to install and operate by reducing overhead. High performance LEDs require fewer circuits and power supplies. These new appliances are designed with energy-efficiency and life safety in mind. Genesis LED G1 Series uses high efficiency optics, combined with patented electronics, to deliver a highly controlled and efficiently focused light distribution pattern in exchange for lower current requirements. Strobes feature field-selectable 15, 30,

Approx. 2,300 / Piece Get Latest Price

Product Brochure
The Edwards / EST SIGA-CR Control Relay Module provides a Form “C” dry relay contact to control external appliances such as door closers, fans, dampers etc.

Approx. 2,200 / Piece Get Latest Price

Product Brochure
Automatic device mapping Each module transmits wiring information to the loop controller regarding its location with respect to other devices on the circuit. Electronic addressing Addresses are downloaded and permanently stored from a PC, or the SIGA-PRO Signature Program / Service Tool. There are no switches or dials to set.  Ground fault detection by address Detects ground faults right down to the device level. Self-restoring 2-gang mounting Designed to ISO 9001 standards

Approx. 1,700 / piece Get Latest Price

Product Brochure
SIGA-PS smoke detector Make -Edwarsd Intelligent Photoelectric Smoke Detector Model SIGA-PS Note: Some features described here may not be supported by all control systems. Check your control panel’s Installation and Operation Guide for details. Features ! Integral microprocessor ! Non-volatile memory ! Automatic mapping device ! Electronic addressing ! Environmental compensation ! Intelligent detector ! Wide 0.67% to 3.77%/ft. sensitivity range ! Twenty pre-alarm sensitivity values, set in 5% increments¹ ! Identification of dirty or defective detectors ! Automatic day/night sensitivity adjustment ! Twin RED/GREEN status LEDs ! Standard, relay, fault isolator, and audible mounting bases ! Designed and manufactured to ISO 9001 standards

Get best price for Edward Smoke Detectors

Approx. 2,100 / Piece Get Latest Price

Product Brochure

Edwards EST SIGA-CT1 Single Input ModuleThe Edwards / EST SIGA-CT1 Single Input Module is an intelligent analog addressable device used to connect one Class B normally-open Alarm, Supervisory, or Monitor type dry contact Initiating Device Circuits (IDC). The Signature Series modules are compatible only with ESTs Signature Loop Controller.

Approx. 2,130 / Piece Get Latest Price

Product Brochure

The Signature Optica Series SIGA-OSHD smoke detector brings advanced optical sensing technology to a practical design that increases efficiency, saves installation time, cuts costs, and extends life safety and property protection capabilities. Continuous self-diagnostics ensure reliability over the long-haul, while environmental compensation helps reduce maintenance costs.

The SIGA-OSHD provides an optical smoke sensor and a rate-of-rise heat sensor with a fixed temperature setting. Together these sensors efficiently detect smoldering fires, as well as fast flaming fires.

Like all Signature Optica Series detectors, the SIGA-OSHD is an intelligent device that gathers analog information from multiple optical sensors, converting this data into digital signals. Utilizing dual optical wavelengths combined with multiple detection angles, the SIGA-OSHD differentiates particles that are not representative of actual smoke. Particle data is input into digital filters which feed a series of ratios removing signal patterns that are typical of nuisance sources, thus reducing unwanted alarms. To make an alarm decision, the detector’s on-board microprocessor measures and analyzes all optical sensor readings and compares this information to preprogrammed settings.

Approx. 2,000 / Piece Get Latest Price

Product Brochure
PHONE JACK FPJ MAKE NOTIFIER

Approx. 2,560 / Piece Get Latest Price

Product Brochure
EDWARD MANUAL CALL POINT SIGA-270

Approx. 1,800 / Piece Get Latest Price

Product Brochure
Siga-OSD smoke detector Make Edward 

Approx. 2,200 / Unit Get Latest Price

Product Brochure

Product Description

The Edwards EST G1RF-VM is a selectable (15, 30, 75, or 110cd) multi-candela strobe.

Operating voltage: 16-33 VDC

COMPATIBLE SYNCHRONZATION SOURCES:
— SIGA-CC1S
— SIGA-MCC1S
— SIGA-CC2A
— SIGA-MCC2A,
— G1M-RM
— BPS6A
— BPS10A
— APS6A
— APS10A
— iO64
— iO500
— Fireshield Plus 3, 5 and 10 zone FACPs.

Wall mount only: flush 2½ inch (64 mm) deep one-gang box

Approx. 2,900 / Unit Get Latest Price

Product Brochure
The SIGA-270 and SIGA-278 series Manual Pull Stations are part of EST’s Signature Series system. The SIGA-270 Fire Alarm Manual Pull Stations feature our very familiar teardrop shape. They are made from die-cast zinc and finished with red epoxy powdercoat paint complemented by aluminum colored stripes and markings. With positive pull-lever operation, one pull on the station handle breaks the glass rod and turns in a positive alarm, ensuring protection plus fool-proof operation. Presignal models (SIGA-270P) are equipped with a general alarm (GA) keyswitch for applications where two stage operation is required. The up-front highly visible glass rod discourages tampering, but is not required for proper operation. EST’s double action single stage SIGA-278 station is a contemporary style manual station made from durable red colored lexan. To initiate an alarm, first lift the upper door marked “LIFT THEN PULL HANDLE”, then pull the alarm handle.                                          

Approx. 1,799 / PIECE Get Latest Price

Product Brochure

The telephone jack in the Fire alarm system consists of a single phone jack mounted on a single gang, stainless steel plate. The stainless steel plate is considered a "FIREMAN PHONE" and can be fixed to any standard single gang box.

The fire telephone jack is usually seen with the addressable fire alarm system in high-rise buildings, but some low-rise buildings have them. Radio communications in large steel structures can only be unstable at best. During emergencies in a high-rise building, the lobby will initiate a command and talk to the team. They can also send people to the electrical room to control utilities, elevators, etc., and communicate via plug-in phones.

If a fire occurs on the 42nd floor, additional personnel and equipment can be prepared on the 40th floor, and an official will be responsible. You will also have an officer in charge of fire fighting. The readiness officer can hang up the phone in the lobby and talk to the incident commander to communicate resource needs. It also left radio traffic for personnel in fire fighting operations.

Approx. 250 / Piece Get Latest Price

The SIGA-SB is the standard base for Signature Series detectors. It connects the detector to the signaling line circuit (SLC), and provides wiring terminals for connection to a SIGA-LED.

Approx. 2,250 / Unit Get Latest Price

Product Brochure
SOUNDER CUM STROBE MAKE EDWARDS 

Approx. 1.52 Lakh / Piece Get Latest Price

Product Brochure

EST3X represents the latest generation of life safety control panels for mid sized applications. With large multimessage displays and innovative controls, intuitive interfaces, and bold colored cabinets — these systems capture the imagination, and catch the eye. But behind the LCD display is where they really shine.

New microprocessors and chipsets take full advantage of the latest advances in computing technology, leading to smarter, faster, higher-capacity processing and more efficient designs.

High performance processing also leads to powerful networking features and versatile digital audio functionality. The wide range of EST3X configurations include standalone operation, networking with up to eight nodes, or integration with an EST3 network comprising as many as 64 nodes — complete with mass notification capabilities and display of security events.

Approx. 1.45 Lakh / Piece Get Latest Price

Product Brochure
EDWARD FIRE ALARM SYSTEM EST-3X

Approx. 2,200 / Piece Get Latest Price

The SIGA-270 and SIGA-278 series Manual Pull Stations are part of EST’s Signature Series system. The SIGA-270 Fire Alarm Manual Pull Stations feature our very familiar teardrop shape. They are made from die-cast zinc and finished with red epoxy powdercoat paint complemented by aluminum colored stripes and markings. With positive pull-lever operation, one pull on the station handle breaks the glass rod and turns in a positive alarm, ensuring protection plus fool-proof operation. Presignal models (SIGA-270P) are equipped with a general alarm (GA) keyswitch for applications where two stage operation is required. The up-front highly visible glass rod discourages tampering, but is not required for proper operation. EST’s double action single stage SIGA-278 station is a contemporary style manual station made from durable red colored lexan. To initiate an alarm, first lift the upper door marked “LIFT THEN PULL HANDLE”, then pull the alarm handle.  

Approx. 2,300 / Piece Get Latest Price

The SIGA-270 and SIGA-278 series Manual Pull Stations are part of EST’s Signature Series system. The SIGA-270 Fire Alarm Manual Pull Stations feature our very familiar teardrop shape. They are made from die-cast zinc and finished with red epoxy powdercoat paint complemented by aluminum colored stripes and markings. With positive pull-lever operation, one pull on the station handle breaks the glass rod and turns in a positive alarm, ensuring protection plus fool-proof operation. Presignal models (SIGA-270P) are equipped with a general alarm (GA) keyswitch for applications where two stage operation is required. The up-front highly visible glass rod discourages tampering, but is not required for proper operation. EST’s double action single stage SIGA-278 station is a contemporary style manual station made from durable red colored lexan. To initiate an alarm, first lift the upper door marked “LIFT THEN PULL HANDLE”, then pull the alarm handle.  

Approx. 90,000 / Piece Get Latest Price

Product Brochure
EDWARD IO SERIES FIRE ALARM PANEL IO-1000

Approx. 65,000 / Unit Get Latest Price

Product Brochure
EDWARDS

Approx. 12,000 / Piece Get Latest Price

Security fire alarm is an alarm system designed to detect the fires, and reduce the fire inside the building. System ranges from small, self-contained noise makers, to complicated multi area systems with computer monitoring and control.

Approx. 2,300 / Unit Get Latest Price

ADWARDS EST G1RF                                      

Approx. 2,100 / PIECE Get Latest Price

The SIGA-HRD is an intelligent fixed temperature/rate-of-rise fire detector. It monitors the temperature of the surrounding air and analyzes the data from the sensor to determine whether to initiate an alarm. The rate-of-rise heat function quickly detects a fast, f laming fire. The fixed-temperature heat function detects fire when the air temperature near the detector exceeds the alarm point.

Approx. 2,100 / Unit Get Latest Price

Product Brochure
SIGA-CR,CT1,CC1